Tag: switching-power-supply

8 Is this fuse a good choice for my Prusa i3's power supply and RAMPS 1.4? 2016-01-20T14:06:31.790

8 What is the power consumption of the heatbed and hotend? 2018-02-23T11:09:20.070

7 Are these the right types of electrical connectors for hooking my Switching Power Supply up to a wall outlet? 2016-01-16T14:40:27.247

7 Running 12v on a 24v heater cartridge? 2016-06-01T00:30:14.640

7 Frightened of Cheap Chinese Power Supply as I hook up the heated bed 2016-09-15T11:24:29.093

6 Power Supply Safety 2016-04-18T01:39:11.703

6 Do I have to buy all new components if I were to get a RAMPS 1.4 that supports 24 V power? 2016-07-26T20:08:08.337

5 Do the TW, THW and THHN or THWN wire insulation types matter in terms of powering RAMPS 1.4 or the MK2a Heat Bed? 2016-04-13T01:05:20.973

4 Safely Hooking a Switch up to an OEM Power Supply? 2016-03-25T13:44:43.030

4 What does the trimpot on my Switching Power Supply do? 2016-04-14T04:23:04.040

4 Why would one choose 12 V from 24 V, from a safety standpoint? 2017-01-30T13:42:55.383

4 24 V heated bed from -12 V and +12 V ATX power supply? 2018-01-18T17:34:36.383

4 MOSFET as a safety feature 2018-02-25T08:58:58.680

4 Speeding up the heating of the heated bed 2018-05-02T23:36:12.267

4 Dual PSU with one switch fuse 2018-05-07T05:42:15.197

4 Anet A8 (Prusa i3) Power Supply Fuse 2018-07-06T00:02:36.563

3 In the standard PC Cable Wire that goes from the wall outlet to the switching power supply, are they standard and what are the wire specifications? 2016-01-25T14:01:51.620

3 Can I use a multimeter to test the outgoing voltage of this power supply? 2016-03-25T15:15:58.453

3 Printer randomly stops, Is the power supply bad? 2016-04-13T17:35:24.807

3 DQ542MA Blown Fuse 2018-06-25T22:28:44.347

2 Is there a G-code to get power supply state? 2017-05-09T14:06:03.460

1 Is 22-Guage Stranded Hookup Wire the correct wire to connect the Switching Powersupply to RAMPs 1.4? 2016-03-25T15:24:37.770

1 Print failing when connecting mains loads 2017-01-29T02:11:14.410

1 Wiring heatbed into Main using ATX 2020-09-18T08:11:19.887

1 How should I connect a separated 5 V source to an Arduino connected to a RAMPS board 2021-02-23T13:04:44.800