Tag: skr-v1.3

5 Setting Junction Deviation in firmware has no effect 2019-10-29T20:55:07.047

5 How to wire P.I.N.D.A. v2 to an SKR V1.3 board? 2019-11-03T00:12:11.557

4 Bigtreetech upload stalled after uncommented REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER 2019-08-10T10:13:09.850

4 Getting wrong measurements on my Kossel Linear Plus after installing SKR 1.3 with Marlin 2.0 2019-09-26T16:58:02.780

4 G28 ignoring Z-Probe X/Y Offsets 2019-10-08T10:11:11.513

3 What UART port to use for RPi GPIO pins on an SKR v1.3 board 2019-12-02T19:09:00.177

1 Switch nozzle contact probe auto leveling with Marlin 2.0 2020-02-15T04:04:00.173

1 Partial underextrusion in walls 2020-02-17T22:00:07.827

1 How to have double extruder and double Z motor on a 5-driver board? 2020-03-12T01:16:56.140

1 Will the TMC2130 V3.0 stepper driver work with the Ramps 1.6 Plus board? 2020-03-24T11:36:54.923

1 Auto bed leveling offset issue 2020-05-25T19:17:55.043

0 LV8729 on kossel issues with print dimensions (steps) 2019-11-11T13:13:10.753

0 Printer froze mid print, stepper motor driver and MCU extremely hot afterwards. MCU seems dead now (?) 2020-04-19T08:58:02.367

0 Error:Printer halted. kill() called! SKR 1.3 TFT35 3.0 2020-08-18T16:26:28.867

0 Hotend functioning inconsistently. PID completed normally, heating to quickly or not at all on print start up 2021-01-11T21:39:37.733

0 I am installing a BTT 24 v1.1 and it appears to be functioning in the 12864 mode with the exception of the top two lines which are gibberish 2021-02-21T02:53:57.473