Tag: retraction

9 Stringing during travel on first layer with Ultimaker Cura 2019-03-22T01:14:22.780

8 What is retract speed & length? 2018-06-09T22:00:55.430

8 Extruder doesn't retract on inner wall lines thereby causing stringing 2018-12-17T18:35:33.537

7 Handling retraction when using a mixing extruder (2 in 1 out) 2019-04-10T15:01:21.300

6 Monoprice Select Mini V2 retraction/stringing problem 2018-09-27T23:54:55.047

6 Retraction Causing Skipping 2018-12-17T13:11:56.090

6 Question about retraction distance and stringing/print quality with PETG 2019-02-07T20:08:58.047

6 How does slipping Bowden tube affect retraction or does it at all? 2019-10-21T16:41:55.947

4 How to remove unwanted filament trails from sharp corners 2018-09-25T23:49:57.660

4 Ultimaker Cura not always telling extruder to retract when traveling 2018-10-21T18:39:42.187

4 Ender 5: Bowden tube shifts in/out of extruder during retractions 2019-08-04T22:26:06.673

4 Under extrusion... sometimes 2019-08-31T17:55:04.807

4 Prints coming out very stringy 2020-03-22T12:51:32.983

3 Stuttering extrusion after layer change 2018-11-24T18:27:50.540

3 Use Gcode Extrusion Speed in Calculations 2019-02-08T21:15:36.847

3 Retraction fine but recovery occasionally just doesn't happen 2020-09-14T09:36:25.420

2 What's the best way to pull out fillament from an all metal print head 2019-08-29T06:46:09.430

2 Why would my extruder remove the filament all the way out after prints? [Ender 3 v2] 2020-09-29T06:24:13.407

1 How reduce the number of retractions? 2019-05-08T22:59:41.807

1 Extusion rate limiting and firmware retract 2020-02-22T02:14:08.137

1 How to unload filament as cleanly as possible using the extruder motor? 2020-02-23T13:12:25.933

1 Titan extruder retraction noise 2020-04-26T12:01:17.620

1 Ultimaker Cura is not always retracting in exported G-Code 2020-07-21T06:32:01.590

1 Stringing between holes 2021-01-10T00:33:58.363

0 Filament doesn't retract for some travel movements using PrusaSlicer 2021-01-14T21:32:47.030