Tag: print-failure

9 What would cause a SLA printer to print a solid block of resin? 2019-12-21T10:17:42.453

6 3D Printer seem to "Forget" Tool Path 2016-09-08T21:39:11.350

5 Evidence of a warped build plate? 2018-12-21T13:05:11.170

5 Printer is Confused-Printing in Air Literally 2019-03-21T03:38:17.487

4 Under-extrusion after a certain amount of successful layers? 2019-01-21T05:58:41.080

4 The part printed correctly except few layers 2019-10-18T14:26:29.653

4 Print failing at random, resulting in a "hairy" mess 2020-04-13T19:47:17.077

3 What causes this "stringing" and can my print recover from this? 2019-01-04T00:08:32.683

3 Anet A8 stops printing 2019-02-24T18:00:25.323

3 Is this articulated Turtle print failing because of over extrusion on a Taz Workhorse? 2019-08-23T06:05:17.517

3 Printing with White pla, problems while printing a benchy boat 2019-09-02T09:38:54.833

3 How to get Sunlu PLA to adhere to the printing bed? 2021-01-15T03:57:17.127

2 Print layer shifting on Alunar M508 Prusa i3 clone 2019-02-05T03:19:35.577

2 Ender 3 print is skipping and dragging up base print lines 2019-02-13T07:05:09.907

2 SLA printing: piece does not stick to supporting structures 2020-03-08T10:42:17.520

1 How does Prusa3D firmware respond to an open or shorted thermistor during a print? 2019-06-27T13:20:24.720

1 Why did my print fall off its raft? 2019-06-30T10:04:45.887

1 Do you have trouble with 3D printer on UPS during short power outages? 2019-07-20T00:33:14.463

1 Resin burns to transparent sheet 2019-09-19T06:26:35.177

1 Ender 3 failing on brim for wide curves 2019-10-25T08:30:31.317

1 Printing Filatech PETG with HyperCube E3Dv6 Clone fails after 3 smooth layers 2020-01-27T07:59:17.187

1 FlashForge Finder turns off mid print and is unable to reset or update firmware 2020-07-02T22:20:06.913

0 Very messy prints with lots of fuzz on edges 2019-09-12T06:20:21.207

0 ELEGOO Mars failed prints every time 2020-03-08T18:02:00.230

0 Can't find a usable temperature for PLA 2020-05-06T21:46:20.793

0 Can't print the top part of a circle 2020-05-17T11:26:30.227

0 Prusa i3 MK3S supports fail to print on bed 2020-09-10T23:05:14.730

0 Under extrusion on one side, but only while printing support material 2020-11-14T04:43:10.497

0 Issues with my print 2020-12-27T17:16:29.543