Tag: layer-height

14 How does the sizes of nozzle diameter and the Z-axis layer resolution work? 2016-06-23T04:24:21.237

10 Is it necessary to have both hot ends on a dual extruder printer at the same height? 2016-02-03T09:30:32.887

9 Do I need to recalibrate z-probe offset every time I switch to a different layer height? 2016-06-07T20:00:05.497

9 First layer overlap on one side 2016-12-16T18:28:38.123

9 Nozzle rubs on previous layers 2017-10-03T04:11:02.003

6 First layer height problem after changing nozzle 2018-05-20T23:14:38.813

5 Adhesion problem (heat bed or extruder issue) 2018-06-14T22:04:54.027

5 Prusa i3 pro b second layer failure 2018-10-29T09:56:29.457

4 Can you print at 0.3 mm with a 0.2 mm nozzle? 2017-05-04T07:17:47.683

4 Print speed and settings for printing below 0.1mm resolution on PLA 2018-09-11T18:40:57.507

4 Prusa i3 MK3 latest release first layer calibration issues 2018-12-15T11:41:11.013

4 Under-extrusion after a certain amount of successful layers? 2019-01-21T05:58:41.080

3 1st layer problems with .1 layer height 2018-03-21T13:07:52.767

3 How specific can I get setting layer heights? 2019-01-06T01:48:16.233

3 ABS prints consistently splitting in the same place 2019-10-31T08:38:27.627

2 Anet A8 - first couple of layer are trash 2017-11-07T21:18:06.827

2 How thick is 0.1 mm? 2018-08-08T16:36:46.010

2 Path of a nozzle crosses over itself 2019-02-17T19:00:18.093

2 Does matching whole Z-motor steps for layer height actually matter on Ender 3? 2019-09-09T18:18:48.333

2 Smaller outer layer height? 2019-12-11T17:33:35.497

2 My first layer becomes solid when sections are supposed to have small separations 2020-02-26T16:33:46.557

1 Partially missed / dragged layers 2020-04-23T21:23:04.590

1 Why do slicers have nozzle size settings? 2020-05-04T21:05:09.853

1 Delamination issue Ender 3 Pro PLA 2020-07-01T17:55:55.550

1 Z-axis scale wrong 2021-01-05T09:23:26.857

0 Layer 1 won't adhere anymore 2018-07-24T18:19:00.927

0 Ender 3 Pro: How to solve the issue with different Z-offsets? 2020-08-31T05:33:16.017

0 Flow + Line Width = over / under extrusion, how does that work? 2020-12-03T08:58:10.123