Tag: knowledgebase

16 What is Thermal Runaway Protection? 2019-03-14T12:58:11.420

13 How may I identify the firmware in use on my 3D printer? 2017-08-30T12:03:14.703

13 Why is it conventional to set line width > nozzle diameter? 2018-09-21T06:13:23.900

13 How to set Z-probe boundary limits in firmware when using automatic bed leveling? 2019-02-03T19:06:07.593

11 How to choose an extrusion temperature? 2016-06-02T15:05:32.857

10 What's the advantage of two z motors? 2016-03-12T00:17:11.157

10 How to center my prints on the build platform? (Re-calibrate homing offset) 2018-07-11T20:25:53.417

9 Slicer line width vs. extrusion multiplier for layer adhesion? 2018-09-21T11:28:37.490

8 Are there any "best" or at least "common" practices to handle allowances in OpenSCAD code? 2017-12-20T02:26:21.183

8 3D printing references for beginners 2018-01-03T18:39:38.413

8 What is a printer console/terminal? 2019-07-13T14:49:41.060

7 How to pause a print to insert something in a cavity using Ultimaker Cura? 2019-07-14T11:06:39.267

6 Fix ghosting problem (damping versus bolting printer to a desk) 2018-06-13T16:29:46.320

6 Why do different drivers change the noise of steppers? 2019-07-02T00:50:19.703

5 Which software do I need to start print something? 2019-04-26T15:16:45.453

5 How to calculate the proper layer height multiples? 2019-09-08T09:17:05.357

4 What causes "ghosting"? 2018-02-03T19:58:11.527

4 What special considerations must be taken when designing parts for 3D printing? 2018-08-23T21:30:56.073

4 How does a UV LCD 3D resin printer work? 2019-04-08T01:05:38.823

4 What is the functional difference between an e3D-Style nozzle, Makerbot MK8 and M6 Chinesium Nozzles? 2019-05-13T13:57:16.847

1 How to activate Power Loss Recovery in Marlin? 2019-07-13T14:26:33.847

1 M502 will reset all configurable settings to their "factory defaults", which settings are those? 2019-11-27T10:20:23.010

1 Updating Marlin Firmware - Step by Step Guide 2020-03-10T09:20:02.260

1 How do I know if a filament is abrasive? 2020-09-09T09:47:39.040

1 How to replace the nozzle in my hotend assembly? 2021-02-01T06:58:27.727

0 What are the pros and cons of Painters tape? 2020-11-04T14:59:36.520

-1 Writing G-Code: length-optimized Test code 2021-01-05T18:04:35.657