Tag: hardware

17 Why all the excitement about linear rails? 2018-01-07T22:57:58.193

10 What's a good way to secure bushings in a 3D printed part? 2018-02-27T18:25:22.440

8 Filament Guides Drag 2016-03-15T23:30:58.747

8 How long is an extruder's/nozzle's life? 2017-05-03T23:03:52.200

7 What is the largest microSD card that a Monoprice Select Mini can read? 2018-01-09T16:21:06.117

7 Does anyone know the thread size (pitch and lead) of the Anet A8's lead screw? 2018-03-17T08:28:28.860

5 Getting rid of hardware parts smell (GT2 timing belt) 2016-03-15T10:38:16.180

5 Printer is Confused-Printing in Air Literally 2019-03-21T03:38:17.487

4 Has anyone used a Shield Buddy (en lieu of a Arduino Mega2560) as the RAMPS 1.4 host board? 2017-01-16T21:09:56.540

4 Can't print anything, clicking and low extrusion 2018-06-09T16:30:27.027

3 Easiest way to build a horizontal hotend mount at home, without printing 2016-03-18T10:21:36.583

3 What should I consider before buying a 3D printer? 2017-09-07T13:53:14.260

3 Did I just destroy my MKS Gen L v1.0 board by shorting the stepper driver? 2019-07-20T01:43:10.443

2 Which belt tension gauge do I need? 2016-04-12T07:13:43.367

2 Anet A8 frame replacement 2017-07-02T20:18:50.810

2 Moving Extruder Gear Assembly 2018-12-20T21:02:58.697

2 How to know if I should replace my power connector? 2019-12-31T16:13:17.980

2 Bed temperature command going to 0 °C with no obvious reason when print is started 2020-01-24T22:20:01.610

1 Tronxy printers 2017-03-16T14:57:18.373

1 Does the Da Vinci line of 3D printers come with a heated bed? 2017-05-16T14:54:42.140

1 Printrbot Metal Plus wireless printing with ESP3D 2019-01-23T22:36:31.240

0 Anycubic i3 Mega y axis off 2020-04-19T00:24:34.340

0 Any defacto standards for controlling new tooling options on generic 3D printers (firmware control and signaling)? 2020-04-20T15:42:31.863

0 Wavy lines throughout print 2020-05-03T06:40:47.693

0 Is it possible to upgrade the CR10-S Pro to CR10-S Pro v2? 2020-05-28T18:54:33.687

0 Springs for tensioning V rollers? 2020-06-26T05:06:51.770

0 Stepper driver Vref not the same after switching motherboards 2020-07-22T18:46:18.110

0 Are control boards switchable? 2020-12-27T02:36:01.657

0 Fixing temperature Issues on I3 Mega / Where to find spare part 2021-01-27T10:47:17.653

0 Standard Settings for AnyCubic Printers? 2021-02-09T16:04:55.333

0 Wanhao Duplicator I3 V2 X limit switch delayed detection 2021-02-17T20:24:03.543