Tag: endstop

15 Which endstops are most precise? 2016-05-05T13:24:37.353

9 Endstops will not trigger using Marlin Firmware 2016-10-29T17:26:57.503

6 Is cutting the arm off the Z-axis switch a good idea? 2016-11-08T19:22:30.303

6 Does moving the z-endstop upwards affect the maximum height of the printable object? 2018-10-30T20:46:41.930

5 Z-axis endstop not functioning after Marlin Firmware installation 2018-08-13T03:40:23.727

5 What is this part and does it have to do with my my z-position is messed up? 2018-12-07T02:57:07.357

4 Connecting Sain Smart Mechanical End Stops to Ramps 1.4? 2016-07-04T22:48:21.577

4 how to level kossel's endstops? 2017-09-07T07:21:49.740

4 MKS board losing power after endstop installation 2018-08-16T15:00:02.430

4 My DIY printer only boots when all my endstops are triggered. Why is that? 2019-10-20T18:43:55.220

3 Unable to install auto-bed levelling sensor into my Anet A8 2017-10-04T19:05:13.593

3 Homing a stepper motor as an extruder using E0/E1 with an limit switch and end stop 2018-04-12T05:36:23.263

3 Z-axis comes down and presses the bed while printing 2018-07-19T18:44:00.893

3 TEVO Tarantula Z-Axis Lowering Too Far After Endstop Triggered 2018-10-14T20:52:42.883

3 Limit Switch problems on RAMPS 1.4 and custom built 3D Printer running Marlin 1.1.0-rc6 2018-12-29T17:15:59.193

2 Marlin endstop hit message deciphering/real position 2019-06-21T17:06:25.790

2 Reprogram Marlin to assign endstop pins to arbitrary tasks [Arduino Mega] 2019-09-23T13:57:16.150

2 How do the MAX endstops work? 2020-04-24T22:12:46.453

2 BigTreeTech mini e3 V1.2 endstop installation 2020-04-28T19:37:49.080

1 Tevo tarantula Z- port burnt 2019-06-28T17:00:23.707

1 Home E / extrude until endstop is triggered 2019-06-30T18:54:04.080

1 Y-min stay triggered 2020-06-14T08:00:20.580

1 Ender 3, why only 3 limit switches? 2020-12-08T22:41:48.920

1 Issue with Z homing on Ender 3 Pro with Marlin 2021-01-30T15:28:11.253

0 How to set Home Offsets and Manual Home definitions in Marlin correctly? 2020-10-21T21:06:31.103

0 Ender 3 - X Axis Cannot Reach True Home 2021-01-22T03:12:31.807

0 3D printer Endstop doesn't trigger in Pronterface when depressed 2021-02-09T18:59:06.687