Stepper motor for CR10-S5 Y-axis

2

1

I need to replace this stepper motor with the following product identification:

Y-axis stepper for the CR10-S5

It’s a Y-axis for CR10-S5 and labeled as JD42HS60-1500A-02F. What type of stepper motor is this?

Peter Lee

Posted 2018-12-18T06:04:41.747

Reputation: 21

Hi Peter, and welcome to 3D Printing.SE! – 0scar – 2018-12-18T07:04:30.113

Answers

3

This is a NEMA 17 motor. It is virtually identical to the NEMA 17 motors Creality uses in most of their 12V products.

In contrast to other companies, Creality uses a different connector with a flat ribbon cable instead of color-coded wires.

The upper line of the label identifies it more clearly:

  • JD Identifies the factory/manufacturer
  • 42 identifies the faceplate size as 42mm square, so a NEMA17
  • HS identifies how the holes are shaped
  • 60 is the height of the motor as 60 mm.
  • 1500 identifies how much power is OK for it, here: 1500mA = 1.5A
  • A specifies our motor has a maximum safe temperature of 104°C
  • - gives us no voltage for this motor, but as you have a CR10, it should be 12V
  • 02F is supposed to tell us something about the wiring and steps per rotation, but I can't find out what.

Side Note: the Creality Ender3 uses 34mm high stepper motors.

Trish

Posted 2018-12-18T06:04:41.747

Reputation: 15 633

Would a voltage rating be relevant ("gives us no voltage for this motor")? I thought that for magnetism it is the current which matters. – Andrew Morton – 2020-08-09T18:58:40.373

@Andrew, yes current matters in magnetism. Any voltage specified on the datasheets is "Tested at" voltages. – user77232 – 2020-08-09T20:35:06.697

@AndrewMorton operation voltage does matter. If you run a machine designed for 12V with 24V you burn it out. If you run it at 6V, you might not operate it at all. – Trish – 2020-08-10T08:36:09.440