How does Z offset (
M851) work with an auto leveling sensor? Does it add the Z offset to the offset of the
G29 mesh? or the
G29 value replaces the
My printer is an Anet A8 with Marlin firmware, I was having issues with the autoleveling sensor and reset the Z offset to 0 and let
G29 get the mesh offsets and its working good now.
I was looking through Marlin G-code page but couldn't figure out how
M851 or vice-versa.
My setup with level issues:
M851 Z0 G28 M211 S0 ;turned endstops off and got a paper to find the zoffset M851 Z-0.59 M500 M211 S1
G29 before printing.