Ender 3 V2 USB connection powers screen, but isn't detected by PC or Pi

0

I am trying to add an Octopi to my Ender 3 V2 but the Pi cannot detect the printer at all. So I try to connect to Windows and same result. The display turns on and is functional, but when checking device manager there is nothing to be found. I am using the 2.0.7 Marlin firmware on the machine and have tried about 6 different USB cables/other ports.

recalm

Posted 2020-10-08T18:26:49.143

Reputation: 11

Did you install the CH340/1 device drivers on Windows? Note that not all ports may work, my previous computer only allowed connection over the usb ports at the back. – 0scar – 2020-10-08T21:47:46.593

I just tried all the ports on the back one by one with device manager open and there was no change. I have the CH340 drivers installed, but not the FTDI drivers since device manager doesn't pick it up in the first place. – recalm – 2020-10-09T00:15:39.760

What board is it exactly? Uploading the firmware worked fine? – towe – 2020-10-09T08:01:37.740

Is the printer switched on? – Andrew Morton – 2020-10-09T12:36:07.567

I have the 4.2.2 board, no issues with changing firmwares. I've tried with the power supply on and off, neither make a difference. – recalm – 2020-10-09T17:05:10.077

Additionally, running dmesg on the Pi doesn't show anything nor does lsusb – recalm – 2020-10-09T18:39:24.400

Are you sure that when you say "powers screen" you are doing this right? The PI will supply power through a typical USB cable. When the Ender 3 is turned off, the power from the PI will power up the printer's control board even if the printer is turned off. If it is turned off, all bets are off as to what will and won't work. Certainly it won't print, but even the main board may be underpowered if only being supplied by the PI. – DavidO – 2021-01-02T21:37:23.870

Answers

1

After trying about 10 USB cables I finally found one that would work with the Ender and Pi. Specifically, it was my Logitech MX Ergo USB cable.

recalm

Posted 2020-10-08T18:26:49.143

Reputation: 11