PLA does not stick to center of the bed anymore

2

I have used my printer (Flying Bear Ghost 4) for the last year and a few days ago I noticed that the center of the heat bed does not stick like it used to.

I think it can be caused by the fact that I always print at the center of the bed (glass) and the center is now too much used.

Is there a way to fix it or will I need another bed?

Eric Brochu

Posted 2020-09-21T01:17:54.223

Reputation: 235

1A photo might be very useful too! Are you sure the center is not greasy? – 0scar – 2020-09-21T05:35:25.607

Answers

1

Actually I washed my heat-bed with some dishes soap and dried it very well, releveled it and now all is fine. I guess it was greasy even if i cleaned it as usual.

Eric Brochu

Posted 2020-09-21T01:17:54.223

Reputation: 235

So it was greasy! Thanks for taking the time to post your solution! Please don't forget to accept it after 48 hours! – 0scar – 2020-09-22T06:58:59.903