BLTouch error Marlin 2.x (on SKR 1.3)

1

I have some issue with my BLTouch (I'm new to bed levelling) : I compiled Marlin 2.x (for my SKR 1.3) for a Antclabs BLTouch, and everytime I power on the printer, it shows this error message: Failed to enable Bed Leveling, echo Bed Levelling off, echo : Fade Height 0, FF, ok:

BLTouch error message on LCD display

The LED of the BLTouch is on, I can still deploy and stow the pin, and do "levelling ABL" but Homing Z (for example) is not working. I linked the config.h and config_adv.h in case needed below:

math45

Posted 2020-03-11T00:34:49.747

Reputation: 111

I have potentially find the problem, need time to confirm, and I'll write here, but thanks – math45 – 2020-03-11T02:03:51.927

it's fixed : it's because I didn't level the bed once after flashing the firmware, once it has been done the error is no more – math45 – 2020-03-11T03:12:49.313

Please post a proper answer in the answer section, not in comments. You should describe in more detail what you did to fix it so it may help others in the future! You can even accept the answer after 48 hours. Thanks! – 0scar – 2020-03-11T05:50:33.463

Please post an answer, and mark it as the accepted answer, as you have solved it, so that the question gets removed from the unanswered question queue. As we are a beta site we need to keep the unanswered queue as short as possible. Thank you – Greenonline – 2021-02-10T14:52:42.227

Answers

2

From a comment can be read that the OP found the solution:

it's fixed : it's because I didn't level the bed once after flashing the firmware, once it has been done the error is no more

0scar

Posted 2020-03-11T00:34:49.747

Reputation: 25 570