Tag: turning

17 How can you stabilize green wood after turning it on a lathe? 2015-03-17T15:26:49.783

13 What minimum amount of equipment is required to start turning bowls? 2015-03-20T15:22:03.543

12 How to cut the centre out of a large round of wood 2015-07-18T11:11:01.453

12 How do I know when my lathe speed is wrong or could be better? 2015-07-19T15:51:32.580

11 What are these blemishes called and how do I avoid them? 2016-02-14T21:54:12.117

10 Which first gouges to get for a beginning turner 2015-03-26T14:50:05.287

9 What are the main categories of wood-turning tools? 2015-03-17T15:23:50.883

9 Why are metal lathes not used for woodturning? 2015-09-24T21:05:15.813

9 What should one consider when purchasing an intro turning chisel set? 2015-10-22T21:56:28.710

8 How do I use this hollowing tool? 2015-03-24T14:38:28.790

8 What do I need to know for basic lathe safety? 2015-05-05T02:23:34.210

8 How heavy a piece of wood can my lathe handle? 2016-03-15T14:47:25.543

7 How do you make nesting bowls from a single piece of wood? 2015-03-20T17:18:55.473

6 Filling pores on a turned bowl while remaining foodsafe/organic? 2015-07-25T17:58:12.407

6 Wood Stabilization on the Cheap 2015-12-02T22:10:41.993

5 How do you turn the bottom of the bowl? 2015-04-01T14:56:24.060

5 What kind of wood blanks should a beginner use for bowl turning? 2016-01-17T18:04:45.367

5 Large hole filler products, what is available 2016-04-08T20:24:59.233

5 Lathe Semi-Automation 2016-08-07T15:02:04.957

4 Can I use sculptor chisels with a lathe? 2016-06-28T22:03:47.157

4 What are recommended angles for different wood-turning tools 2016-11-07T17:50:09.913

3 How do you use a 2D template with a lathe? 2015-11-10T02:08:50.843

3 What type of lathe do I need for duplicating parts 2016-02-25T04:39:53.970

3 Recommended tools for a lathe 2016-11-18T18:58:04.490

2 How can I control the "reddening" of Red Alder as it dries? 2017-06-06T15:56:10.080

1 What does a torn fiber look like compared to a cut fiber? 2016-02-26T01:35:50.987

1 Turning a convex arc 2016-10-14T17:06:39.970

1 What finish can I apply to mixed end-grain/cross-grain bowl that's sanded to 7000? 2016-11-04T09:39:25.163

1 Carving a wood bowl or cut without a lathe 2017-12-12T18:48:46.963

0 How to use this type of chuck without grooves/teeth? 2017-06-26T08:26:26.090

0 Best method for making segmented rings for wood turning? 2017-07-25T19:18:07.830

0 Why is my wood screw getting stuck in my bowl when turning with my lathe chuck? 2017-10-30T22:09:50.893