Tag: dust-collection

27 What advantages does a dust collector have over a shop vac? 2015-04-04T01:58:43.350

18 Why and when should I wear a dust mask? 2015-06-04T19:25:47.363

16 Is PVC pipe safe to use for a dust collection system? 2015-05-17T18:15:30.150

14 What sort of dust collection system would be adequate for a two-car garage? 2015-03-25T16:30:35.473

9 How to improve a sliding miter saw dust collection? 2015-04-07T16:03:58.123

9 Can you hook up two shop-vacs in parallel to increase airflow through a dust collection system? 2017-03-29T18:18:50.763

8 How can I enclose the top of my contractor table saw for better dust collection? 2015-04-19T03:18:32.873

8 Why is my dust collector way too loud? 2015-09-10T23:47:44.007

8 Can I put more than one extractor on a dust collection system? 2017-10-12T10:03:36.823

7 3/4 HP dust collector for a single tool (Bandsaw or jointer) 2015-08-31T21:46:16.970

7 Cloth covered flexible ring or a bag clamp in a dust collector? 2015-10-20T15:47:45.937

6 How to calculate dust collection horse power per feed and bends 2016-01-27T17:06:01.080

6 How are vacuum hose sizes measured? 2016-02-11T04:50:15.893

6 Can I expect an improved weekend shop experience from installing an air filtration system? 2016-02-25T05:42:01.493

6 Can you use Festool dust extraction with non-Festool tools? 2016-06-29T03:32:53.973

5 Should I locate a centralized dust collector in a roof crawlspace above a garage shop? 2015-03-19T05:33:30.000

5 Two-part router table dust collection, both four inch? 2015-04-06T14:01:41.070

5 What can you use instead of PVC pipe for your dust collector? 2016-03-16T18:42:15.890

4 Will this setup severely reduce the CFM from my dust collector? 2016-09-03T14:58:30.460

4 Respirator / Dust mask for hand tools? 2017-02-22T17:30:10.780

4 Dust Control on a Table Saw Not Intended for It? 2018-01-25T04:59:56.733

4 HPLV vs HVLP dust collector 2018-02-05T14:52:08.337

4 Is it important to minimize volume of duct in a dust collection system? 2018-02-12T04:42:03.990

3 Correct "piping" (hosing) for adding a mini-cyclone to a shop vac 2015-11-10T16:19:27.303

3 Will a dust collector motor be harmed by venting outside and not using filters? 2015-12-15T22:39:45.117

2 static shocks from festool router 2017-09-03T07:39:52.517

1 ShopVac with Cyclone hoses, 2.5 or 4.0? 2017-01-03T23:19:32.947

1 PVC duct for dust collection: Glue the pipe and fittings together, or will tape suffice? 2018-01-30T01:00:20.540

0 What kind of cfm can I get out of a 1/3 hp motor? 2018-02-27T20:37:37.657