Tag: cisco-commands

46 How can I see which switchports are not in use? 2013-05-20T13:30:08.600

24 Accidentally Removed Allowed VLANs from Cisco Switch Dot1Q Trunk 2013-05-28T05:28:43.470

17 Cisco - display ALL routes using a single command 2013-07-04T21:52:32.873

14 How can I reset a VPN tunnel on a Cisco ASA? 2013-05-20T12:14:16.593

14 BGP "no synchronization" command not showing up in running-config 2013-06-03T19:39:34.960

10 Deconfigure an interface in IOS with one command 2013-05-23T12:10:51.790

10 How can I speed up CLI typing in Cisco IOS using shortcuts? 2013-05-25T15:26:01.463

10 How can I disable SIP on IOS 12.x 2013-05-27T19:22:03.370

10 Locate a host on Network 2013-06-05T23:14:33.303

10 QoS between two VLANs with Cisco 881 Router (IOS) 2013-10-02T16:32:57.033

9 PPPoA ADSL Configuration with external modem on Cisco 891 2013-05-22T03:31:41.317

9 Monitor specific traffic type on a Cisco router 2013-05-23T06:24:09.890

9 Cisco: prevent vlan's of communicating with eachother on cisco router (ACL alternative) 2013-05-23T07:42:01.780

9 Why does "show adjacency" take so long to run? 2013-05-27T08:55:16.563

9 Cisco IOS: Show ip route output order 2013-08-06T16:12:09.613

8 Cisco config example for Policy Based Routing 2013-05-23T19:38:32.047

7 Configuring redundancy using floating static 2013-06-30T10:47:05.757

7 What does logging synchronous command do? 2016-01-04T11:13:21.013

6 Chassis temperature and Fan status on Cisco 3548 switch 2013-08-08T10:58:37.327

6 About the inside local and outside local and inside global and outside global 2013-08-10T06:47:14.160

6 "Local Policy Denied Prefixes" in 'show ip bgp neighbor' output 2013-09-13T16:02:22.930

6 SNMPv3 Setup - Cisco 3750 2014-06-06T15:35:39.300

6 Why is Cisco enforcing X:X:X:X::X for link-local addresses when the standard says FE80:/10? 2016-04-27T18:55:53.223

6 What is the difference between "ip domain name" and "ip domain-name"? 2017-08-28T00:41:40.390

5 Cisco 867 forward UDP port range 2013-05-25T10:52:49.307

5 How do I create an SSL CSR via CLI for Cisco Prime? 2013-06-13T10:55:34.747

5 SNMP and Syslog in configuration 2013-08-04T23:07:45.037

5 Reconfiguring Layer3 Switch to enable IP routing and become the default gateway 2013-08-17T00:18:34.287

5 Show connected (up) interfaces on cisco devices 2014-02-17T13:15:53.210

5 Meaning of the ip default-gateway L2 switch 2016-01-10T21:25:56.627

5 Traffic marking is not working properly in QoS 2017-07-25T08:56:45.923

5 What commands do I run to change IP NAT settings for a Cisco 2800 series router 2018-03-08T09:59:59.267

4 OSPF LSA Refresh Time 2013-05-31T17:23:49.203

4 time based interface shutdown on cisco router 2013-10-04T08:43:41.627

4 "Protected" switchports on a Cisco 881W 2013-12-06T16:24:10.653

4 Cisco Router Telnet Connection Refused 2014-04-03T08:46:17.017

4 Enable traps on FIB (Forwarding Table) changes 2014-05-10T16:46:00.550

4 Order of entries in "show ip bgp x.x.x.x" 2015-02-25T17:40:17.740

4 "transport input" for AUX port in Cisco routers 2015-02-27T12:21:02.410

4 Need Zyxel Speedlink router to communicate with Cisco 886VA router 2015-11-06T11:05:22.090

4 Cisco - Changing LACP rate from slow to fast 2016-02-13T18:21:13.623

4 Show all routes from one next-hop via CLI 2016-03-02T02:27:23.087

4 Blacklisted DFS channels on Cisco WLC 2016-06-10T21:36:01.880

4 How would I track down what port a device is on remotely? 2016-09-16T21:30:10.913

4 Should I always use "no ip address" command? 2018-01-21T18:44:52.847

4 After I set the "router rip" networks, how can I check it? 2018-11-02T02:57:31.093

3 Cisco: No autostate on GigabitEthernet interfaces, any alternative? (not working) 2013-05-22T05:35:26.680

3 Enabled VPN -- Site to site -- Cannot access internet now .. Cisco ASA 5505 2013-10-01T21:44:42.840

3 Creating multiple trunk ports on a Cisco ME3400 2013-11-19T16:41:57.850

3 How to disable CDP on multiple sub-interfaces from physical bearer? 2014-05-13T10:49:49.307

3 Cisco Switch (Cayalyst 2960-X) How to add a rule to the access list that filters out l2tp packet when a specific MAC address appears in it? 2015-06-25T14:07:29.300

3 About "show interface switchport" output 2015-11-12T21:44:52.913

3 How to clear all static NAT entries with just one command? 2016-07-18T15:21:18.237

3 Cisco Catalyst 2960 X MAC access list 2016-10-27T15:53:51.143

3 Time Cisco Router reload not always mentioned 2017-01-03T08:46:43.120

3 Console, Monitor and Buffer Logging 2017-03-08T15:26:44.613

3 Telnet or SSH into a Cisco router 2017-10-04T17:05:10.863

3 Create a internal connection between ISR 4451 and EtherSwitch submodule 2018-01-05T06:55:07.780

3 How to Disable telnet on Cisco switch totaly? 2018-05-17T07:18:27.007

3 spanning tree RootGuard question on vPC switches 2018-11-30T17:37:40.110

2 Cisco router dot1Q monitoring 2013-10-11T05:59:08.290

2 Cisco ASA 5550 stuck on boot from tftp 2014-06-07T13:45:41.177

2 How to Block Torrents Using NBAR 2015-07-27T09:15:06.393

2 Cisco - #show inventory vs #show interface 2015-09-20T04:58:24.243

2 How to enable DHCP on Cisco router 2016-02-15T10:45:19.530

2 How to view active MAC address only on a port 2016-02-17T00:30:23.500

2 Cisco Digital Optical Monitoring Command 2016-02-21T23:39:10.833

2 Alternative command for show interface status 2016-06-20T17:12:33.190

2 Disable empty power slot on Cisco 2960xr 2016-09-13T14:10:56.717

2 Configure ethernet ports at an router in packet tracer 7 2016-10-08T19:22:11.183

2 What do BGP activity numbers mean? 2017-02-27T18:57:58.930

2 Why do I get different serial number from "show version" than from "show inventory" 2017-03-08T20:34:56.350

2 Building Static Routing Network 2017-04-22T14:51:05.677

2 IOS 15.2(4)E4 pipe next command changed? 2017-06-20T19:55:37.180

2 Best way to setup VRRP if a router fails 2017-10-16T00:28:06.737

2 How to configure site to site VPN between Cisco ASA and Cisco router? 2017-12-19T23:09:14.483

2 Firewall and VPN functionalities for a Cisco ISR4321 V/K9 2018-01-16T09:49:17.147

2 Fix our Cisco switch overwhelmed by console logging 2018-07-26T08:43:18.430

2 Diffrence between "wr" and "copy running config to startup config" 2018-08-05T11:33:50.943

2 VLANs still exist on my switch as I reset it 2018-11-01T07:03:08.513

2 Set password of a Switch to "C?1sc0" using CLI in Cisco Packet Tracer 2018-11-15T17:59:50.653

1 How can I log authentication errors in 3G routers? 2013-05-29T06:37:59.110

1 Listen-only (stealth) CDP on IOS 2014-05-22T21:45:50.303

1 List ports which do not have a given property 2015-02-25T18:43:07.633

1 confused about cisco firewall configuration when allowing all other traffic on certain ports (src dst) 2015-04-09T17:47:23.340

1 VLANs not connecting properly to switch/router 2015-05-25T01:26:48.863

1 tacacs server hostname problem 2015-06-16T22:52:30.140

1 How do I remove a vlan from a trunked port 2015-09-23T20:05:33.893

1 Configure Log format Cisco ASA firewall 2015-10-07T08:22:52.830

1 Able to test AAA to Radius Server from router but unable to log into Router with A.D 2015-10-20T18:53:08.167

1 Connecting two routers in different networks via Static Routing 2016-01-10T09:09:29.490

1 port on Layer 2 switches Mac Address usage 2016-03-24T10:55:31.983

1 Does the archive command use memory in switch? 2016-03-28T12:55:41.550

1 Removing source ports from a SPAN session on a cisco nexus switch 2016-04-24T17:28:08.780

1 How do you use strict/lose source tracerouting with Cisco IOS 2016-05-06T19:44:36.937

1 How to know the interface utilization on a Cisco switch? 2016-05-19T16:42:00.600

1 Offset-list inbound outbound clarification 2016-06-23T06:43:23.717

1 Cisco ASA network object host changes with NAT 2016-06-28T04:25:56.243

1 Can someone tell me how to make this show cmd work? (want to see what ports we can disconnect) 2016-08-31T19:56:31.703