Tag: piping

29 How fast does solid waste fall in vertical drain pipes? 2015-02-04T12:47:47.763

8 How to seal a pressure vessel 2015-02-14T18:31:57.687

7 Force required to empty a syringe 2015-03-11T19:39:51.347

6 Pipe seized to inaccessible coupling - how to attach a new pipe? 2015-05-03T15:41:28.040

6 Why prefer any other pipes over plastic pipes for drainage and culverts? 2015-06-02T11:28:52.947

6 What is the correct pipe size for a 2inch pipe? 2016-10-21T06:59:42.180

6 Is there a way to reduce leaks and infrastructure damage when turning water on and off at the scale of city? 2018-01-21T17:26:12.227

5 How does a union joint with two male threads work? 2016-04-03T17:43:38.397

4 How to bend iron pipe into a spiral guide rail for stair lifters 2015-02-27T05:36:45.817

4 Why prefer plain pipes over corrugated pipes for storm sewage and culverts? 2015-04-16T07:57:00.897

4 Service Life of a Flashback Arrestor 2016-01-18T10:30:20.017

4 What are these bent shapes on this elbow in a compressor suction pipe? 2016-02-25T03:36:22.737

3 How can I fit a DN16 flange to a DN10 flanged pipe? 2015-01-21T04:05:04.740

3 What boundary condition should I use for the edge of a blind flange? 2015-06-19T20:43:22.043

3 Measuring pipe bolt torque without a torque wrench 2015-07-01T05:09:35.830

3 How often do you need to check torques on bolted flanges? 2015-07-02T15:26:59.073

3 Water pump at top floor or bottom? 2016-04-30T05:13:05.843

3 What tool does one use to inspect pipe bevel angles? 2016-06-17T10:09:59.127

3 City Wide Hot-Water Heating System 2016-10-10T00:34:28.137

3 What is the difference between NPT and pipe diameter? 2017-09-08T20:32:58.390

2 What is the name of the part that allows a steam wand to have a moveable joint? 2015-02-03T02:24:17.837

2 Matching up cam lock or cam and groove coupling 2016-10-03T19:19:46.113

1 Pump suction and discharge sizes 2015-03-21T07:36:12.390

1 Piping construction, flanged connection - Difference between Collar and Flat collar 2015-11-04T12:20:03.823

1 What is the pressure-temperature rating for a stainless steel Class 150 nipple? 2016-04-05T20:15:18.450

1 What would happen to a misinstalled globe valve? 2016-10-09T11:02:07.857

1 Calculating discharge on the pipe diameter and the pressure? 2017-02-28T08:54:15.880

0 Force and Headloss Calculations for Three Stage Condenser 2016-11-30T00:19:04.757

0 Compressive/Tensile forces in thin cylinder under UDL 2016-12-20T19:42:30.543

0 How to do a pressure drop or saltation velocity calculation on pneumatically conveyed solids in slug flow? 2017-07-18T19:30:53.163