Tag: bolting

8 Can nuts safely be removed from bolts where the threads have been intentionally damaged? 2015-03-11T21:51:51.500

8 Many small bolts, or few large bolts? 2015-06-07T03:00:57.307

7 What bolts should I specify with Weathering Steel? 2015-02-05T13:21:08.610

6 Are standard structural bolts acceptable for all cold climates? 2015-02-07T20:05:11.193

6 Do bolts become tighter or looser at cryogenic temperature? 2016-06-09T23:33:50.507

5 What could be the downsides of leaving twist-off bolt splines in the interior of exterior columns? 2015-10-13T01:37:52.977

4 What method can I use to make a pivot point in an aluminum linkage? 2015-01-20T22:53:44.837

4 Are stress concentrations a concern when replacing rivets with high strength bolts? 2015-03-13T19:11:53.423

4 Effect of varying diameter bolts on shear stress under eccentric loading 2016-03-03T05:15:29.027

3 How to determine the number of effective anchors in a base plate? 2015-02-19T03:24:30.607

3 What boundary condition should I use for the edge of a blind flange? 2015-06-19T20:43:22.043

3 Measuring pipe bolt torque without a torque wrench 2015-07-01T05:09:35.830

3 How often do you need to check torques on bolted flanges? 2015-07-02T15:26:59.073

3 How would you refer to a bolt mounting slide as opposed to a simple hole? 2016-01-15T10:44:29.430

3 What is the name for a bolt hole with a slot that allows the bolt to be inserted or removed when the nut is loose? 2017-02-01T20:31:33.050

3 Determine force distribution from a bolt pattern 2017-11-13T10:49:37.763

2 Stiffness of members in a bolted joint 2016-08-16T09:12:27.337

2 How the amount of bolt's preload in a single lap joint can change the natural frequencies? 2018-01-22T12:15:08.950

1 How is a self-locking hex nut (ISO 7040) used? 2015-06-01T13:07:21.207

1 Rotating a bolt around the centre 2016-01-01T09:35:52.363

1 How to build a pivot linkage for a robot. 2017-02-20T11:18:24.717

1 How to make screws stay tight under high vibration? 2017-06-25T11:34:57.940

1 Maximum shear force of metric steel bolt 2017-06-30T06:03:35.980

1 Derivation on torque required to raise load, isn't there a force disapearing? 2017-09-13T17:52:58.883

0 Convert translational stiffness to rotational stiffness of a screw 2016-10-05T13:36:14.820

0 Flanged connection studbolt length calculation 2017-03-14T10:35:12.160

0 How to determine materials and torque for a flat setscrew that won't loosen, slip, or mar 2017-05-06T18:16:46.177

0 Instrumented Bolt - Conversion of measure strain/stress to clamping force 2017-08-09T15:38:06.603

0 What is the hardware called that can step a lever N degrees upon manual force? 2017-11-05T21:41:05.130

0 Correct term for non-countersunk flat hex screw/ bolt? 2017-11-24T17:18:41.950