Tag: thermistor

12 E3D Thermistor Alternative 2016-01-16T10:50:04.393

8 MINTEMP error after crash 2016-12-08T20:56:15.760

6 What kind of silicone glue should I use to attach my thermsistors? 2016-03-20T00:06:31.977

6 Marlin temperature sensor problem 2016-07-24T14:14:27.093

6 Anet A8 reading 739°C from the extruder thermistor! 2017-12-10T15:04:39.263

6 RAMPS won't PID tune and shows unreal temps 2018-03-12T05:31:51.617

6 Hotend heating failure too short before limit 2018-09-03T16:13:37.507

5 Are the thermsistors identical for both the heatbed and the extruder head? 2016-03-25T13:48:11.593

5 Heated bed thermistor placement 2016-06-07T15:06:01.907

5 New thermistor isolation, how? 2017-01-15T14:01:40.907

5 Thermister stops reading temp after a few seconds. (Marlin 1.1.8, Tronxy X5s stock Melzi board) 2018-08-09T19:30:42.280

4 Stainless tip for thermistor 2016-03-07T08:08:59.980

4 How can I insulate my thermistor? 2017-05-09T16:58:42.367

4 MK8 extruder showing 500+ °C on temperature sensor? 2018-03-18T21:41:31.840

4 Change hotend thermistor input in Marlin 2019-06-08T18:37:34.153

4 Thermal runaway with specific prints 2019-11-22T13:00:47.630

3 RAMPS PLUS 2 and E1 socket problem (K200 Delta, but related to the PCB , not printer) 2018-07-26T20:40:18.700

2 How to decrease sensitivity to heat-bed temperature? 2019-05-07T10:34:34.253

1 How does Prusa3D firmware respond to an open or shorted thermistor during a print? 2019-06-27T13:20:24.720

1 Weird temperature reading using thermistor on MKS GEN L v1.0 AUX-2 analog pins 2019-08-29T02:59:27.697