Tag: prusa-i3-rework

10 Is the weather a problem for MDF frames? 2016-01-12T19:33:04.263

8 Is this fuse a good choice for my Prusa i3's power supply and RAMPS 1.4? 2016-01-20T14:06:31.790

8 When building a RAMPS 1.4 based printer, can I safely plugin just some of the components to test if they are working? 2016-01-26T05:38:44.720

8 3D printer stepper motors only going one direction and skipping in the other 2017-12-22T22:12:51.127

7 How is a J-Head Extruder Head attached to the Prusa i3 rework? 2016-01-16T13:28:24.050

7 Frightened of Cheap Chinese Power Supply as I hook up the heated bed 2016-09-15T11:24:29.093

7 Silver Solder specifications for hot end heating element 2017-01-09T16:25:36.013

6 How do you make sure you have the right voltage on the trimpots on an A4988 stepper driver? 2016-07-04T23:50:08.490

5 Why does my MKS Base not recognize my thermistors? 2016-02-06T13:53:01.323

5 What grade of wire is required for the heating element on a J-Head extruder? 2016-12-01T14:50:28.943

5 Changing the home position on a Prusa i3 MK2 2018-02-20T17:13:26.473

4 Safely Hooking a Switch up to an OEM Power Supply? 2016-03-25T13:44:43.030

4 Connecting Sain Smart Mechanical End Stops to Ramps 1.4? 2016-07-04T22:48:21.577

4 Print Nozzle Dragging and Smearing Filament while Printing 2017-10-17T19:58:04.243

4 Selecting G-code files from SD with serial 2017-12-25T19:32:20.323

3 My endstops have 4 female plugs, but the examples on the RepRap Prusa i3 Site have 3; what are each of them for? 2016-01-17T01:23:41.323

3 Can I use a multimeter to test the outgoing voltage of this power supply? 2016-03-25T15:15:58.453

3 How do I determine that the electronics are working with the test firmware? 2016-04-14T04:09:00.080

3 Prusa I3 starting print above heating bed? 2017-07-06T06:59:00.280

2 Can I use a pin header in a breadboard to wire up the z-axis motors in parallel? 2016-05-02T15:58:04.713

2 Heater cartridge connector for Original Prusa i3 MK2S 2017-08-26T14:39:26.787

2 Z axis Control of Prusa i3 2018-02-28T18:30:30.120

1 Is 22-Guage Stranded Hookup Wire the correct wire to connect the Switching Powersupply to RAMPs 1.4? 2016-03-25T15:24:37.770

1 Magnetic field around the printer 2017-06-18T06:34:12.083

1 Migbot extruder loading 2019-06-20T17:29:50.430

0 Prusa i3 MK3S Z axis moving down in calibration wizard 2019-03-24T16:55:26.320