Tag: heat-management

14 Efficient and easy way to thermally insulate the heat block of the hotend? 2016-06-01T08:56:51.677

9 How to utilize/calibrate print fans for PLA? 2016-07-12T08:08:41.043

8 How much insulation do I really need? 2016-12-01T11:53:29.057

8 Heated Bed vs Heated enclosure for large scale printer 2017-08-22T11:58:52.227

6 Proper way to power down a FDM printer 2018-02-23T04:57:20.143

5 Weird ripping and warping of ABS print 2017-08-22T19:32:11.643

5 Insulate hotend on Makerbot Smart Extruder 2018-06-13T19:19:04.670

5 Creating a heated chamber from a very large heated bed 2019-09-04T14:35:14.170

4 FlashForge Creator Pro Tool Failure! Temp limit reached 2016-05-11T22:38:09.423

4 How can I insulate my thermistor? 2017-05-09T16:58:42.367

4 Creality CR-10S Pro 3D printer heated bed turns off after first few layers: normal? 2019-02-04T02:40:16.637

4 Chamber heating using hysteresis in Marlin 2019-11-22T00:43:44.027

3 Increasing hotend temperature to compensate for increased filament throughput 2017-01-07T14:21:16.837

3 Delta Kossel 3d Printer Heatsink issues 2017-03-31T21:38:52.067

3 German RepRep Neo can't heat the extruder 2018-05-29T10:56:45.593

3 Reprap RAMPs over heating issues 2018-09-21T04:23:35.593

3 Which capacitor to change on CR-10S S500 motherboard? 2018-11-21T05:47:39.893

3 Heater cartridge with 7.2 ohms - 12 or 24 V? 2019-05-15T10:13:13.997

3 Makerbot Replciator 2x - restarts after heating 2019-10-13T16:46:04.653

3 What are the variables for PID control? How to use M301? How to use this command to switch from PID to bang-bang? 2019-11-10T16:01:22.870

2 Getting E1 Thermal Runaway errors, even after replacing the heating element on Tevo Tarantula 2018-12-10T01:20:00.720

2 Clogging due to heat creep: buy new cooler or new hotend? 2019-02-07T17:45:47.377

2 Bed and nozzle temperature jumping 2019-04-14T09:39:38.207

2 Two 12 V heater elements in series in a dual hotend 2019-09-14T01:35:33.537

1 Anet A8 won't print properly 2018-11-24T23:20:56.270

1 Unable to hit hot end temperature with part cooler on 2019-01-23T03:19:03.197

1 Watts of filament extrusion 2019-06-04T10:17:23.857

0 Extruder temp is too high 2017-03-12T20:57:22.407