Tag: bowden

8 How to straighten PTFE tubes? 2017-01-13T19:24:03.443

7 Can I increase retraction length on an E3D v6 beyond 2 mm if I have a really long Bowden tube? 2016-03-29T21:18:42.210

7 PTFE pulled into extruder gears 2018-10-24T08:07:14.670

5 Extruder Clicking without Extrusion Problems 2018-07-21T15:58:23.627

5 What are the limiting factors when trying to print flexible filaments with a Bowden extruder setup? 2018-10-07T04:59:55.353

5 Installing bowden tube into E3D V6 2019-02-28T19:08:22.303

5 What makes an extruder right handed? 2019-05-13T15:15:41.143

5 How does slipping Bowden tube affect retraction or does it at all? 2019-10-21T16:41:55.947

4 What do you call this effect in 3D printing and how can I remove it? 2018-07-08T08:15:58.327

4 Would adding fiberglass packaging tape to a bowden tube be beneficial? 2018-08-09T19:22:11.633

4 Switched to a Bowden setup. Should I retract the filament out at the end of a print? 2019-11-27T06:42:42.957

3 Can I use Bowden hotend instead of Wade for a direct extrusion? 2018-04-11T10:22:31.987

3 Bowden tube clog 2018-09-15T22:04:02.290

3 Horizontal defects when linear_advance enabled? 2019-09-14T22:53:10.930

2 Clogging due to heat creep: buy new cooler or new hotend? 2019-02-07T17:45:47.377

2 Ender 5: Bowden tube shifts in/out of extruder during retractions 2019-08-04T22:26:06.673

1 Smooth transition between a PTFE tube and the back of a push-fit coupler 2017-01-15T20:22:27.473

1 Filament gets coiled inside the extruder 2018-12-07T13:02:39.453

1 Ender 3 stock bowden tube inner diameter? Worth upgrading? 2019-05-22T16:38:32.120